| If any of our products, under normal
operating conditions, prove to be
defective in material or workmanship within one year from the date
of
shipment from Honeywell Sensotec, they will be repaired or replaced
free of charge. (see Warranty/Repair policy.)
Honeywell Sensotec also provides repair services for products
which are not under warranty. If you are in need of a repair quote,
contact our Service Department by phone, fax, email or use our convenient
on-line RMA form.
 |
We calibrate and certify the following instruments:
- pressure transducers
- force gauges
- pressure calibrators
- pressure gauges
- torque gauges
- load cells
- LVDTs
- accelerometers
Calibrations:
- Standard Calibration (calibration factor/shunt cal factor)
- System Display Data Calibrations
- Multipoint calibrations up to 21 Points
- Tension & Compression for load cells
- ANSI/NCSL Z540 Calibration (ex.,"ISO"; "Before & After")
- ASTM E-74 Calibration
- Special Calibrations
ISO Guide 25 and 17025 accredited calibrations for new products
and recalibration.
Calibrations are performed in compliance with applicable ANSI/NSCL
Z540-1-1994 requirements. Laboratory equipment is maintained in
accordance with MIL-STD-45662A. All calibrations are traceable to
NIST (National Institute of Standards & Technology).
|
